How To Build Your Own Laptop

how to build a computer

That particular process is tricky, so we won’t get into that, for now. Besides, you probably already know what you’re doing as an enthusiast if you’re dealing with those components. Next up, take your SATA power and connect it to any storage drives. If you happen to have a something mounted onto the front of the case, run this SATA power cable through the PSU shroud, appropriate grommets or holes, and into your front mounted 2.5-inch drive. This is a good opportunity to plug in the SATA Data cables between any storage drives and the motherboard as well. It’s also a good time to plug in your USB 3.0 header, USB 2.0 header, and audio passthrough.

  • Do this by removing the screw that secures the backplate to the chassis.
  • It’s important to note that any LED lights , need to be oriented correctly, with the + and – cables installed into the + and – pins on the board.
  • Your motherboard’s documentation will show you where on your motherboard these connectors attach.
  • However, over the years, the desktop PC industry has become quite standardized.
  • They are exceedingly fragile, any slight collision can bend the pins, which might cause functional errors.
  • But if you’re using high-end parts, particularly energy-sucking video cards , your power needs could raise to 1,000 watts or even more.

But keep in mind that buying the one you want has become a bit more difficult lately because of a major and ongoing GPU shortage. Snagging a deal on them is harder but not impossible, especially when you’ve got our tips on how to buy graphics cards to guide you. Connect the case plugs and buttons to the motherboard. A double-wide row of pins — the location of which will be noted in your manual — runs the USB ports, buttons for reset and power, and activity LEDs for power and storage. Be sure that your motherboard is well supported across its entire surface, as it is possible to put too much pressure on the motherboard when installing RAM if you push too hard. This is unlikely, but as with any steps in this guide, take care, and if in doubt, double-check everything before proceeding.

Introduction: How To Build A Pc

Check out our best guides for each component and then check for incompatibilities using our brief checklist below. Avoid electrostatic discharge when installing components. Wear a static wristband or regularly ground yourself by touching a metal part of the case before handling components. Some components will come with protective plastic on them so they aren’t scratched up. Make sure you remove this or you computer will start to smell like burning plastic. Windows 10 purchased from a store or online comes on flash drive now, all you have to do is plug in the flash drive and boot from that.

how to build a computer

However, you’ll need a discrete GPU if your CPU doesn’t have onboard graphics in order to connect your monitor. The first thing to do is remove some slot covers on the back of the case. This is for the HDMI, DVI, and DisplayPort to show through, letting you connect the best monitor of choice. Before securing the motherboard in place, you’ll have to install the I/O shield which covers the area around your rear ports.

Build Your Own Laptop Faq

If you’re doing liquid cooling, the radiator needs a spot to mount to the case, so check for 240 or 360 millimeter rad mounting locations at the front or the top. The top is the best location for temps as the rad will exhaust directly outside the case. With these factors in mind you can pick out the case to fit your style.